20180423
- XTLW2 Printer improvements
- Move X Y motors off end of Shafts to be belt driven:
- Extend shafts to outside of frame X Axis:
- New 3d printed pillow block with additional fixing for Y Axis microswitch
- 1 x 350mm 8mm shafts
- 2 x MR148ZZ
- 2 x M4 2020 Hammer Nuts
- 2 x M4x10mm Button Head
- 2 x 3mm xxx screw / nut for Y Axis microswitch
- Extend shafts to outside of frame Y Axis:
- New 3d printed pillow block with room for X axis microswitch bracket
- 1 x 350mm 8mm shafts
- 2 x MR148ZZ
- 2 x M4 2020 Hammer Nuts
- 2 x M4x10mm Button Head
- X Axis microswitch bracket
- New 3D printed part
- 1 x M4 Spring drop in T-Slot nut
- 1 x M4x10mm Button Head screw
- 1 x 3mm xxx Screw / Nut for X Axis microswitch
- Move X Y motors:
- 2 x Flat Nema 17 Bracket
- 8 x M3x6mm screws (M3x8mm prob better but none on hand)
- 4 x M5 Spring nuts
- 4 x M5x8mm Button Head screws
- Belt drive between above shafts & X Y Motors:
- GT2x6mm Bore 8mm 32 tooth (for light down gearing) pulleys on shafts
- GT2x6mm Bore 5mm 20 Tooth pullleys on motors
- Looped GT2x6mm belt 400mm on X
- Looped GT2x6mm belt 280mm on Y
- Extend shafts to outside of frame X Axis:
- Move X Y motors off end of Shafts to be belt driven: