Todo

20190731 Inital swap of RC4 / 2 x pinballs

20190730 Soldering station

20190317

  • Large TVs against Gge door (temporary)
  • Middle window:
    • 6 x FCabs inline workbench
      • Cabs in place, rough wooden bench top
      • Needs power run, shelving, on left after determine:
        • where PCs live
        • where soldering/rework station lives
    • Box shelving above:
      • partially done, pending decision on what tops 100 drawer cab
    • 100 Drawer cab:
      • Wall off left side
      • 42″ HD TV mounted on side of cab
      • Leave room for 55″ Tv to slide out?
  • Soldering / rework station:
    • Tambour cupboard purchases and in place DONE
    • Run power
    • Run lights
    • Setup internally
  • Lundia:
    • Isle 3 middle:
      • Bottom shelf rubber mats height
      • Next shelf Steel cutoff saw, Arc welder / Plasma cutter
      • Top shelf: linear rails, acme leadscrews etc
      • Remaining: TDB
    • Simexperience:
      • Tidy, sell?
    • RC4: rotate 100 degrees

  • 3030 / 3060
  • Construct Bench to go under
  • Cutting bench:
    • 20190923: NEW SAW
    • Level left side
    • Make fence & Fit digital readout
    • Sort right side
  • Boxes to keep:
    • Shelf on top of tilt door 20190923 partly done
    • Shelf above window
  • Loose iCreme containers etc below corrugated cardboard rolls:
    • empty some into new 100 drawer cabinet
  • New Mill parts:
    • Cancelling this project as not enough room and no longer worth the hassle so:
    • Construct bench opposite existing mill SELL compound table
    • Construct Mill (mount head to compound table SELL mill head
  • Pinballs (Prioritised):
    • Remove broken plastics from IJ
    • Fix & LED CFTBL & sell
    • Fix STTNG ball sensors
    • Fix JD flipper
    • LED TFTC
  • Bikes:
    • Sell Ego $1500 incl
    • Sell C600 $8000 incl
    • Fix PGO
    • Sell ZX? $16000 incl
    • Buy H2?

201909 485k