New 202303 Scale notes: https://www.starwars.com/databank/tie-fighter https://www.starwars.com/databank/x-wing-starfighter Will try ratio 13/8 = ~1.625 Star_Wars_X_Wing__S-foils_in_attack_position_5175115 Huge amount of stringing, would’ve been a great print without that.. Same again but Tie_Fighter_1150625 Looking to size same as 40% X-Wing above, X-Wing = L 80mm, Tie Fighter should be 50mm Star_Wars_X_Wing__S-foils_in_attack_position_5175115 Then again retraction 1.4 still stringing..
Category: 3D Model specific notes
https://www.thingiverse.com/thing:3429201
Fittings, passthrough or not? https://www.captubes.com/fittings.html
https://www.thingiverse.com/thing:1608509 Borg Cube 20180417 Anycubic Delta Linear Plus 2014 old natural PLA filameent (has printed ok, a bit brittle but then I am only used to ABS previously) Cura 3.2.1 Sides V4: Upsized X 116.8933mm to 155mm = 1.325996 scaling Cura = PLA 0.2mm, 30%, Build Plate Adhesion = Yes FAILED = bad model